Veris-technologies 3150 Soil EC Mapping System - Operating Instructio Manuel d'utilisateur télécharger pdf (Page 54)

Pub. # OM17-EC

6-20

Procedure #7: Lubrication

• Pinch point hazard: to prevent injury, stand clear when raising or lowering any part of the Veris

MSP. Disengage automatic cycling function before working around unit.

• Install all transport locks before transporting or working underneath.

Rockshaft pivot points – Each pivot (located at the left and right) contains

an upper and lower grease zerk. Due to the limited motion of the

rockshaft, these should be lubricated on 20-hour intervals. This may

vary based on the number of times the unit is raised and lowered.

Figure 7.1

Rachet jack -- 20 hour intervals

Figure 7.2

Electrode coulters Pivot --In all but the most extremely rocky conditions, the coulter electrodes

should not flex in the field, thus minimal movement will be realized at the pivot. 80-hour

intervals should be sufficient.

Pivot grease

zerks (2 per

hangar; 4 total )

grease zerks

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 60 61

Pas de commentaire

Veris-technologies 3150 Soil EC Mapping System - Operating Instructio Manuel d'utilisateur Page 54