Veris-technologies EC Force Probe - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 25)

OM17-P4000 Force/EC

6-1

Section 6

Maintenance and Lubrication

Proper maintenance and lubrication of the Veris P4000G will allow you to collect high

quality EC and force, and greatly extend the useful life of the unit. Veris Technologies

strongly suggests that you follow the following guidelines:

MAINTENANCE: Storage of Auxiliary Instrument and EC – Force Probe

The auxiliary instrument and probe are water resistant; store system indoors or under

roof. Water damage to electronic components is not covered by warranty.

MAINTENANCE: Electrical Continuity and Isolation

It is advisable to perform this test on a routine basis (weekly or every 20-25 hours of

data collection) to ensure you are obtaining reliable data.

1) Probe electrode isolation – Check isolation of the dipole to the point with a

Digital Multi Meter if the dipole is properly isolated, a reading of 12K ohm

should be obtained.

Figure 1

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32 33

Pas de commentaire

Veris-technologies EC Force Probe - Operating Instructions Manuel d'utilisateur Page 25