Veris-technologies MSP EC and pH (1997-2008 floppy disk drive 1.02E) Manuel d'utilisateur télécharger pdf (Page 32)

Veris Technologies

Pub. #OM MSP03-1

4. Insert pH electrodes into electrode holder. Finger-tighten plastic screws. Install BNC cover

on external controller to keep moisture out of BNC connectors. Leave BNC cover on

whenever unit is outdoors.

5. Row cleaner/firming wheel (if equipped): Pull MSP forward and check depth of row cleaner

and firming wheel. Cleaner should be clearing residue ahead of sampling shoe, but not

gouging into soil. Adjust height of cleaner relative to firming wheel by removing adjustment

pin and re-positioning disk attachment.

6. Closing disks (if equipped): Adjust closing disks as needed to properly close trench and bring

residue over row-cleaned zone. Do not operate these deeper in soil than necessary.

Closing Disks

depth adjustment

Closing Disks

angle

adjustments

When wash jets are

properly aligned,

overspray is

minimized and water

bubbles out top of

electrode holder as

shown here.

Adjust height of cleaner relative

to firming wheel by removing

adjustment pin and re-

positioning disk attachment.

When installing BNC cover, route

electrode wires under box; center

box on white pad, and tighten

wingnut finger tight. Keep cover

installed even when electrodes

are removed.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 61 62

Pas de commentaire

Veris-technologies MSP EC and pH (1997-2008 floppy disk drive 1.02E) Manuel d'utilisateur Page 32