Veris-technologies pH Detector - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 12)

OM17-pH Detector

3-2

-Flush and fill tanks with tap water; clean any foreign matter out of tank using clean-out cap. Make

sure inlet is in sump (Figure 3), and strainer is attached to end of line (Figure 4).

Figure 3 Figure 4

Pump priming: In order to prime the pumps, loosen quick coupler and operate pump until water

flows (Figure 6).

Wash adjustment: This was set at the factory but may have slipped during shipping. Wash

brackets should be opposite each other, with jets as close as possible to electrode holder, and still

allow electrode holder movement. Jets should be 1/4” (6 mm) below electrodes. When wash jets

are properly aligned, overspray is minimized and water bubbles out top of empty electrode holder

as shown in Figure 5. To adjust wash jets, use 3/16” allen wrench to loosen set screws holding

wash jet blocks and rods (Figure 6).

Figure 5 Figure 6

set screws

Quick

coupler

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 28 29

Pas de commentaire

Veris-technologies pH Detector - Operating Instructions Manuel d'utilisateur Page 12