Veris-technologies Precision Rate Controller - Operation Manual Manuel d'utilisateur télécharger pdf (Page 6)

Pub.# OM17-PRC

2-1

Calibration--Rate

Turn on Controller Console by pressing On/VR key. Green light above On/VR

key will illuminate when power is on. Adjust desired planting rate by using the

Up/Down arrow keys to change the Set rate. (See Figure 4)

Figure 4. Set the desired Rate by using the Up/Down arrow keys.

Press Function key until Calibration Number window appears. (See Figure 5)

Select drive calibration number from chart if available. If calibration number is

not known, enter 1000. Use Up/Down arrow keys to set Calibration number.

Press Function key until the Calibration window appears as shown in Figure 5.

Figure 5. Example of calibration number. Enter new calibration number using

Up/Down arrow keys. Press Function key to advance to Calibration Mode.

Figure 6. Rate calibration window. Press up arrow key to enter calibration

mode.

1 2 3 4 5 6 7 8 9 10 11 ... 26 27

Pas de commentaire

Veris-technologies Precision Rate Controller - Operation Manual Manuel d'utilisateur Page 6