Veris-technologies VIS-NIR-EC-Force P4000 Spectrophotometer - QUICK R Manuel d'utilisateur télécharger pdf (Page 2)

14. Begin probing: with probe mast

vertical, insert probe into soil until top

of window is not visible.

12. Verify spectra

rate is changing;

this shows

communication with

auxiliary and

spectrometer cases

is maintained.

13. The Auxiliary (Aux display) window

provides user-selectable information about

the system. For Probing, select No. 9-force

or No. 11-depth

11. Before probing complete all steps above. Make sure

Reference Check (Ref Check) and GPS signal lights are

green, and all Auxiliary Case lights are green. Additional Dark

and References may need to be collected. Ref check light will

turn green when sufficient references have been collected.

16. While probing: watch display for following:

-Log light must be green while collecting data; if not green

stop immediately and determine problem

-GPS data light is green

-auxiliary case information—green lights and data

-system will ask to collect a dark and reference every 10

minutes—several dark and references may be required

-if system fails to respond, inspect spectra window (see

Step 12) to check if system has lost communication with

auxiliary and spectrometer cases. If system has locked,

reboot software in the following sequence: 1) exit software,

2) turn off power to cases, 3) disconnect USB’s from

computer then reconnect, 4) turn on power to cases, 5)

restart software. If restarting computer is required, exit

software, shut down computer and follow steps 2-5.

15. Pressing Probe button begins storing spectrum data and

auxiliary data until probe is stopped or raised. Once insertion

is initiated, do not stop or reverse unless problem has

occurred or desired depth is achieved. Data recording stops

when probe is raised. GPS and Log lights must be green for

data to be recorded.

1 2 3

Pas de commentaire

Veris-technologies VIS-NIR-EC-Force P4000 Spectrophotometer - QUICK R Manuel d'utilisateur Page 2