Veris-technologies VIS_NIR Spectrophotometer Probe - Operating Instru Manuel d'utilisateur télécharger pdf (Page 22)

OM17-P4000VIS-NIR

4-1

Section 4

Field Operation - Electronics

Operating software - This will need to be completed every time the software is started.

Open Veris operating software:

Figure 1

Figure 2

Folder icon to select working directory.

A field folder must be selected before

any steps can be completed. Note:

Each field or site must have its own

folder.

Once the desired

directory is found,

click on current folder.

BEFORE STARTING:

1. Before taking any

data let system run

for 20 minutes to

allow the

spectrometers to

stabilize.

2. Connect

spectrometers to

PC.

3. Open Veris software

4. The port order must

be set (see Setting

Port Order). This

needs to be done

the first time the

software is run on a

machine, after that

the port order will be

stored for future use.

Port terminology

may be labeled

COM or ASRL.

Both are acceptable

if port number is

correct.

Press EXIT or F12 when ready to quit the software; this will

ensure the port order will be saved.

Set software for either probe or shank mode. If the

incorrect mode is selected and system check or

acquisition entered, then the auxiliary case will need

to be reset by shutting off power and turning back on

before entering software again.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 81 82

Commentaires sur ces manuels

Pas de commentaire

Veris-technologies VIS_NIR Spectrophotometer Probe - Operating Instru Manuel d'utilisateur Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Veris-technologies VIS_NIR Spectrophotometer Probe - Operating Instru