Veris-technologies Quad 2800 Soil EC Mapping System - Operating Instr Manuel d'utilisateur télécharger pdf (Page 21)

OM17-Quad2800

5-2

SoilViewer Troubleshooting

EC Surveyor is not found

Check to ensure the com which the EC Surveyor is connected to is present under the device

manager. To get to the device manager go to StartSettingsControl PanelSystem Click on

the Hardware tab and then click on the device manager button. Click on the “+” sign next to Ports

and make sure the port is listed here. In this case a USB to serial converter is being used and the

port is listed as USB Serial Port (COM33)

Figure 1

If the port is not listed here, then unplug and replug the USB – Serial converter cable and ensure

the power is on to the EC surveyor. If USB – Serial port is still unavailable then reinstall the

drivers. If you are using the provided USB-Serial converter part #41377, then the drivers can be

located on the Veris SoilViewer disk see Reinstalling USB-Serial Converter Drivers, if a different

USB- Serial Converter is being used, then follow the manufactures instructions for driver

installation.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Pas de commentaire

Veris-technologies Quad 2800 Soil EC Mapping System - Operating Instr Manuel d'utilisateur Page 21