Veris-technologies Quad 2800 Soil EC Mapping System - Operating Instr Manuel d'utilisateur télécharger pdf (Page 5)

OM17-Quad2800

2-3

Figure 4. EC Surveyor (rear)

Figure 5. EC Surveyor (front)

Figure 6. DataLogger (rear)

Power port:

The Soil EC Surveyor is shipped

with an accessory power cord.

If an alternative connection is

desired, make sure that the unit

is properly connected to a power

connection that is not controlled

by the ignition switch. If

connecting directly to the

battery, we suggest a 3-amp in-

line fuse is installed between the

battery and the instrument.

EC Signal:

EC Signal Cable

extension from

implement attaches

to the EC Surveyor

here. Route cable

properly to prevent

damage. Signal test

load also attaches

here—used to test

EC Surveyor.

EC Data out:

Attach serial cable

here and other end

to Sensor

DataLogger or

laptop PC.

GPS input:

Connect GPS cable here.

It is designed to accept

GPS input in NMEA 0183

format via an RS232

connector.

(GPS must send GGA and

either VTG or RMC strings

at a 1hz rate, at 4800 baud,

8 data bits, 1 stop bit, no

parity.)

On/Off:

Turns power to EC

Surveyor on and

off.

Power:

When lit, this red

LED indicates EC

Surveyor is powered

up.

Data Status:

When lit, this green LED

indicates data is being sent

out serial port. If not lit, EC

values are negative or GPS

signal not received.

Fuse:

This allows the fuse to be

replaced, with a 1A

fastblow fuse, if blown.

1 2 3 4 5 6 7 8 9 10 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Veris-technologies Quad 2800 Soil EC Mapping System - Operating Instr Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Veris-technologies Quad 2800 Soil EC Mapping System - Operating Instr