Veris-technologies pH Detector - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 17)

OM17-pH Detector

3-7

pH Controller Set-up

After calibration, you may wish to change the pH Controller default parameters. Press 2 and enter

Setup menu. (Press 4 to Exit this window).

Figure 120

Figure 21

Maximum log time is the longest time in seconds the pH controller will wait for the pH readings to

settle. The controller usually cycles before this maximum time is reached. The minimum setting

for the maximum log time is 20 seconds. (Tip: use 20 seconds unless there is a special reason to

allow a longer wait time) Press 1 or 2 to adjust the sample time, press 3 to continue to the next

screen.

pH Data Recording

Figure 22

From the screen above, press the #1 key and this screen appears.

Figure 23

Select #2 pH to collect pH data. #4 returns you to the initial start-up screen. Pressing #2 brings up

the next screen:

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 28 29

Pas de commentaire

Veris-technologies pH Detector - Operating Instructions Manuel d'utilisateur Page 17