Veris-technologies OpticMapper - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 20)

Pub.# OM17-OpticMapper

4-6

Field Operations—Soil EC Surveyor with SoilViewer software

The EC/OM Mapping software will automatically detect which ports the Veris EC Surveyor and

OpticMapper are connected to, and begin communicating. If the either is not detected, the

software will wait 45 seconds for the connection of the electronics and search again; this will

repeat until both instruments are connected. If the electronics are not found, unplug the serial or

USB cables and reconnect them to the PC. If the connections are still not made refer to SoilViewer

troubleshooting. The conditions for mapping and storing the data are as follows. The user must be

going a speed greater than 1 mph, there must be a GPS signal received, the EC Comm Light must

be green, indicating the PC and EC Surveyor are communicating properly, and either of the EC

values has to be greater than -1. When all these conditions are met, the Saving Data light will be

green and the points will be mapped.

Before mapping run the OM system check to ensure everything is operating correctly.

If mapping has stopped, files may be appended by selecting a previous file when prompted at the

startup of the software.

Figure 18

User selectable

point width

User selectable plot

colors, click on color to

change.

Selectable zoom

functions for viewing

maps

OM System Check

Displays when program is

searching for connection to

EC Surveyor, this only

happens at startup.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 58 59

Pas de commentaire

Veris-technologies OpticMapper - Operating Instructions Manuel d'utilisateur Page 20