Veris-technologies OpticMapper - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 24)

Pub.# OM17-OpticMapper

4-10

Field Condition

Field should be in a uniform state. Mapping after intensive primary tillage is not recommended. The

soil must have a minimum of 20% available water, and cannot be frozen. If rocky conditions exist,

slow down and make sure rock guards are in place

Mounting options

Figure 26 3-point Mounted Figure 27 Pull Tongue

Turn the top link to adjust the tilt so that the unit runs level. This is the optimum setting for all field

conditions. Extending the top link will cause the rear of the unit to move down. Shortening the top

link will cause the inverse.

Speed

Proper field operating speed depends on field conditions. Because of the importance of consistent

contact, the unit must not be allowed to bounce over rough fields at high speeds.

Pulling Vehicle

The implement may be pulled with a variety of vehicles: 20-50 hp tractor or a 4WD pickup.

• Be very careful when mapping stubble fields with a gasoline engine pickup. Be prepared if a fire

starts.

Pas de commentaire

Veris-technologies OpticMapper - Operating Instructions Manuel d'utilisateur Page 24