Veris-technologies Quad 2800 Soil EC Mapping System - Operating Instr Manuel d'utilisateur télécharger pdf (Page 13)

OM17-Quad2800

4-1

Section 4

Field Operations—Soil EC Surveyor

Attach the signal cable to the quick connect coupler at front of frame, and to Signal port on back of

EC Surveyor. Connect serial cable, GPS, and power cords to ports on rear of EC Surveyor.

Figures 1a and 1b

EC Surveyor display readings

Here are the display readings that you will see when operating the EC Surveyor:

Figure 2

The unit is ready to operate. The Surveyor is informing you of the firmware version its

programmable interface chip (PIC) contains. Immediately the screen will change to the operating

screen below:

Figure 3

Ground speed

(from GPS) in

miles/hour

GPS status: may

read GPS, DGPS,

RTK, or None. If

None, no GPS signal

is received and no

data will be sent out

serial port.

Shallow (Sh) and Deep (Dp) soil EC

readings. If negative, no data will be

sent out serial port.

Note: The EC Surveyor display screens

are the same whether using Veris

DataLogger or laptop PC for recording.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Pas de commentaire

Veris-technologies Quad 2800 Soil EC Mapping System - Operating Instr Manuel d'utilisateur Page 13