Veris-technologies EC Force Probe - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 14)

OM17-P4000 Force/EC

5-1

Section 5

Field Operation

P4000-S

Installation

The P4000-S is designed to be installed in ¾ ton – 1 ton pickups and due to the wide

range of bed and frame dimensions on the market, there are no mounting holes in lower

frame flange. Some drilling and fabrication will be required. You may choose to

perform this on your own, or may wish to have a local welding or truck shop do this for

you.

Steps:

1) Properly lift probe assembly in folded position with a minimum of two nylon straps

and lower into pickup bed.

2) Center side-to-side in bed and so rear portion of skid frame rail is 14” forward of

farthest point on rear bumper (Figure 1). This will ensure that foot will not contact

bumper when the skid is in the retracted position.

3) Ideally 4 mounting bolts (½” Gr5) are adequate for fastening the probe skid to the

frame of the truck. Choose mounting location based on frame obstructions such

as spring hangers, fuel tank hoses, etc. This will take some time, measuring both

top and underneath the bed to make sure bolts will align with skid frame

4) Locate all four positions and fabricate “L” straps from at least 3/8” material and

bolt or weld to frame. Make sure that fuel tanks, fuel line, and brake lines are not

in danger of being drilled or welded. Drilling is preferable and two ½” bolts in the

vertical position are adequate. (Figure 2)

Figure 1

14” from rear edge

to rear of bumper

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 32 33

Pas de commentaire

Veris-technologies EC Force Probe - Operating Instructions Manuel d'utilisateur Page 14