Veris-technologies OpticMapper - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 34)

Pub.# OM17-OpticMapper

5-3

OpticMapper Troubleshooting

To ensure the OpticMapper is operating correctly, attach the test load to the OpticMapper

controller-port marked Optical Power port.

Figure 2

Once attached turn power on and go to data acquisition mode on Datalogger or SoilViewer.

Figure 3

OM values should be:

Sensor 1: 833

Sensor 2: 289

Readings are acceptable if within 10 numbers from these. Readings outside of this range could

indicate possible controller problems.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 58 59

Pas de commentaire

Veris-technologies OpticMapper - Operating Instructions Manuel d'utilisateur Page 34