Veris-technologies OpticMapper - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 56)

Pub.# OM17-OpticMapper

6-22

Procedure #9: Removing EC Surveyor Cover: Microchip Replacement and 3100 to 3150

Resistor Change

It may be necessary to open the EC Surveyor to perform one of the service functions listed below.

Disconnect power cable. Remove four screws in front end plate, and pull end plate slightly to free

up top panel. Be careful not to pull too hard and disconnect any wires.

Figures 9.2 a and b.

Slide top panel out to reveal circuits.

Figure 9.3

1 2 ... 51 52 53 54 55 56 57 58 59

Pas de commentaire

Veris-technologies OpticMapper - Operating Instructions Manuel d'utilisateur Page 56