Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 10)

Pub. #OM17-MSP3

2-1

Section 2

Electronics Overview and Set-up

The MSP3 electronics kit and optional DataLogger kit are shown below.

Figure 1a MSP3 electronics kit Figure 1b MSP3 DataLogger kit

Use protective shipping/storage case to protect electronics components whenever electronics are

shipped. Keep all diagnostics and operations manual with system when mapping.

Mount electronics in a location that is as free as possible from dust, vibration, and electrical

interference. Display should be visible to operator and shielded from direct sunlight. ‘

The supplied GPS(Figure 2) is configured to operate

with the MSP3 electronics.

The use of any other GPS requires the correct

settings. The GPS needs to output only two NEMA

strings(GGA and VTG OR RMC). The system will

not run with more than two strings. The strings

need to output at 4800 baud and 1Hz refresh rate.

USB Serial

Adapter

MSP3 EC

Test Box

Simulator

Mounting

Bracket

Reference

Block

OM test

load

MSP3 EC

test load

SoilViewer

Protective

Case

Three-way

power

adapter

DataLogger

SD card

reader

Power Cord

Figure 2

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 115 116

Pas de commentaire

Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur Page 10