Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 31)

Pub. #OM17-MSP3

4-11

The EC OM pH-MSP3 Mapping software will automatically detect which ports the Veris

OpticMapper /EC Controller and pH Controller are connected to, and begin communicating. If

either is not detected, the software will wait 45 seconds for the connection of the electronics and

search again; this will repeat until both instruments are connected. If the electronics are not found,

unplug the serial or USB cables and reconnect them to the PC. If the connections are still not

made, refer to SoilViewer troubleshooting. The conditions for mapping and storing the data are as

follows. The user must be going a speed greater than 1 mph, there must be a GPS signal

received that includes position and speed (GGA and either VTG or RMC), the OM/EC Comm Light

must be green, indicating the PC and OpticMapper with EC Surveyor are communicating properly,

and either of the EC values has to be greater than -1.

Before mapping, run the OM system check and pH calibration to ensure everything is

operating correctly. pH controller settings can be modified to adjust the wash and cycle

times for specific field conditions.

Figure 34

Pinch point hazard: to prevent injury, stand clear when raising or lowering any part of the

Veris MSP3.

Install all transport locks before transporting or working underneath.

Always use the service stands when working underneath the MSP3.

After clicking on EC OM

pH- MSP3 the user will

be prompted to input the

EC file name. All OM

and pH files will be

named the same as the

EC. Files may be

appended to by

selecting a previously

created VSEC file.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 115 116

Pas de commentaire

Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur Page 31