Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 99)

Pub. #OM17-MSP3

6-25

2. Functions Aren’t Working in Manual Mode

-follow troubleshooting flow chart below and see related procedures in Maintenance and

Service Procedure Section.

1. Sampling mechanism locks up or mis-cycles

-press “1” to disengage, turn external controller to Manual and check prox sensor adjustment

(see Procedure #4 in Maintenance and Service Procedure Section.)

-check DGPS signal

-if status of sampler shows “Cycling” for long periods, set sampler shank to shallower position.

In hard soil, sampler shoe may not be able to penetrate to the depth needed to move plate off

prox sensor. (see Procedure #4 in Maintenance and Service Procedure Section.))

Figure 11.4

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 115 116

Pas de commentaire

Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur Page 99