Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 51)

Pub. #OM17-MSP3

4-31

Figures 78a and 78b

4. Insert pH electrodes into electrode holder. Finger-tighten plastic screws. Install BNC cover

on external controller to keep moisture out of BNC connectors. Leave BNC cover on

whenever unit is outdoors.

5. Row cleaner/coulter: Pull MSP forward and check depth of row cleaner and coulter.

Cleaner should be clearing residue ahead of sampling shoe, but not gouging into soil.

6. Closing disks (if equipped): Adjust closing disks as needed to properly close trench and

bring residue over row-cleaned zone. Do not operate these deeper in soil than necessary.

Figures 80a and 80b

Closing Disks

depth adjustment

Closing disk

angle

adjustments

When wash jets are

properly aligned,

overspray is minimized

and water bubbles out

top of empty electrode

holder as shown here.

When installing BNC cover, route

electrode wires under box; center box

on white pad, and tighten wingnut finger

tight. Keep cover installed even when

electrodes are removed.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 115 116

Pas de commentaire

Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur Page 51