Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 65)

Pub. #OM17-MSP3

5-1

SECTION 5

Maintenance and Service

Soil EC

Rockshaft pivot points Each pivot (located at the left and right) contains

an upper and lower grease zerk. Due to the limited motion of the

rockshaft, these should be lubricated on 20-hour intervals. This may

vary based on the number of times the unit is raised and lowered.

Figure 1

Rachet jack 20 hour intervals

Figure 2

Electrode coulters Pivot --In all but the most extremely rocky conditions, the coulter electrodes

should not flex in the field, thus minimal movement will be realized at the pivot. 80-hour intervals

should be sufficient.

Pivot grease

zerks (2 per

hangar; 4 total )

grease zerks

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 115 116

Pas de commentaire

Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur Page 65