Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 69)

Pub. #OM17-MSP3

5-5

• If wheel does not fall freely, loosen hex-head bolt (1)

and slide wheel arm out just until wheel and arm move

freely. Retighten hex-head bolt (1) according to grade:

1⁄2in Grade 5 bolt on 25 series, 75 ft-lbs (102 N-m).

1⁄2in Grade 8 bolt on 25 series, 110 ft-lbs (149 N-m).

6. Keep turning hex adjuster and moving wheel arm

until the wheel is adjusted properly. When satisfied,

tighten pivot bolt (2) to 110 ft-lbs (149 N-m).

Null4:

Adjusting Gauge Wheel Scrapers

Refer to Figure 14 (bottom view)

Scrapers are optional, and may be useful in moist or

sticky soils that tend to accumulate on gauge wheels

and reduce intended sensing depth.

To adjust scrapers:

1. Loosen nut (5).

2. Slide scraper (6) toward gauge wheel (8) until

scraper touches tire.

3. Slide scraper (6) away from wheel (8) leaving a

1⁄8in (3mm) gap at (7) .

4. Rotate scraper left and right around bolt, making

sure it cannot touch tire if bumped in field. If it can

touch tire, back scraper away from wheel until it cannot.

5. Center scraper angle on bolt (5) until gap (7) is constant.

6. Tighten nut (5).

Replacing Row Cleaner

1. Loosen and remove three nuts

2. Now the depth bead wheel and cleaner can be

removed and replaced.

Figure 15

Figure 13

Figure 14

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 115 116

Pas de commentaire

Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur Page 69