Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 96)

Pub. #OM17-MSP3

6-22

Procedure #9 SoilViewer Troubleshooting

OpticMapper or pH controller is not found

Check to ensure the com which the EC Surveyor/OpticMapper is connected to is present under the

device manager. To get to the device manager go to StartSettingsControl PanelSystem

Click on the Hardware tab and then click on the device manager button. Click on the “+” sign next

to Ports and make sure the port is listed here. In this case a USB to serial converter is being used

and the port is listed as USB Serial Port (COM33)

Figure 9.1

If the port is not listed here, then unplug and replug the USB – Serial converter cable and ensure

the power is on to the EC surveyor. If USB – Serial port is still unavailable then reinstall the drivers

following the manufactures instructions for driver installation.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 115 116

Pas de commentaire

Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur Page 96