Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 57)

Pub. #OM17-MSP3

4-37

Mapping with SoilViewer

Attach the pH serial communication cable to an available COM port on your computer. Connect EC

signal cable and power cords to ports on rear of OpticMapper/EC Controller, connect the GPS to

the GPS in of the OM Comm. cable, then connect the serial output of the OM Comm. to any

available COM port on your computer using a standard serial cable. If serial port is not available

on PC, then a USB to Serial converter can be used with the OpticMapper with EC Surveyor

provided the drivers for the converter are installed and functioning properly.

SoilViewer startup display

Figure 94

Figure 95

EC – EC Surveyor connected to PC

OM – OpticMapper and GPS connected to PC

pH – pH controller and GPS connected to PC

EC and pH – EC Surveyor and pH controller connected to

EC and OM – EC Surveyor and OpticMapper connected to

EC OM pH-MSP3 – OpticMapper/EC Controller Surveyor

and pH controller connected to PC

To acquire data with the MSP3 only EC OM pH- MSP3

can be used. This will allow the user to collect all three

sensor readings, or collect only EC and OM if desired.

To acquire EC, OM and

pH data select Acquisition

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 115 116

Pas de commentaire

Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur Page 57