Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur télécharger pdf (Page 73)

Pub. #OM17-MSP3

5-9

Wash System

If wash water develops algae, flush and fill tanks with tap water; clean any algae or other foreign

matter out of tank using clean-out ball valve (right side). Set wash system ball valve (left side) to

open position, allowing water to flow to pumps. Clean filter at least once per week of operation.

Remove plug and turn on ball valve to clean.

Figures 22a and 22b

When temperatures are dipping below freezing, prevent freeze damage to the wash system as

follows: close ball valve between tank and pumps, open up check diaphragms and drain,

disconnect quick couplers and run pumps until empty. If unit is to be left outside for long periods of

time over winter, it is advisable to add RV antifreeze to tank and run pumps for a couple of minutes

to fill all lines with anti-freeze. Purge system of anti-freeze before collecting any pH data.

Figure 23

• Pinch point hazard: to prevent injury, stand clear when raising or lowering any part of the

Veris MSP. Disengage automatic cycling function before working around unit. Install all

transport locks before transporting or working underneath.

open check

diaphragm

and drain

water in line

to prevent

freeze

damage

ball valve on

plug removed

tank clean-

out

ball valve

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 115 116

Pas de commentaire

Veris-technologies MSP3 - Operating Instructions Manuel d'utilisateur Page 73